STL Antennas — Too Much Height?
     

Fig. 1:An STL path with water reflection.
Did you know that microwave STL antennas can be too high?

A microwave signal can reflect off of water, as shown in the exaggerated drawing in Fig. 1.

If both antennas are within line of sight of water, and the water is in an unfortunate location, two signals can arrive at the receiving antenna — one from the transmitting antenna and one from the reflection off the water. If the reflected signal arrives out of phase with the direct signal, it can cause the received signal to be severely degraded or even unusable.

This problem can be solved by intentionally blocking one of the antennas from the over-water reflecting path. Trees are often a good source for intentionally blocking a path, but terrain and taller buildings can also serve the purpose. In Fig. 2, we simply lowered the height of the transmit antenna to cause the trees to block the path towards the water, which will eliminate the reflected signal.

Fig. 2:STL path using terrain to block reflections.

The reflective medium does not have to be water. A swamp, a marsh or even a flat pasture might cause a reflection. Make sure you have enough height to clear the Fresnel zone, but don’t install the antennas higher than necessary without investigating reflections.

Jeffrey Gehman is engineering associate at Kessler and Gehman Associates in Gainsville, Fla.

Send your story ideas or tips to rwee@nbmedia.com.


Rating People: 3   Average Rating:     
Comment List:

Hi Dave - That is true! However the tip above was focused only on microwave reflections causing self-interference from being too high when water/ marsh/ swamp or other flat areas are between the two sites. We could've added something related to interference to others, although in our experience the possibility of reflections off water seems to be lesser known.
By Jeff Gehman on 2/27/2013
Another factor is interference. You may be able to better cooperate with other licensees, reducing or eliminating interference concerns by reducing the height of your STL antennas.
By Dave Barnett on 2/27/2013

Post your comment

Your Name:  Required
Your Mail:       Your email will not be published.
Your Site:    

max. 800 characters


Posts are reviewed before publication, typically the next business morning. Radio World encourages multiple viewpoints, though a post will be blocked if it contains abusive language, or is repetitive or spam. Thank you for commenting!