Henry Engineering Powerclamp Series 10
Jun 1, 2010 12:00 PM, Reported by Erin Shipps, associate editor
Surge suppressor
Powerclamp Series 10 wire-in parallel TVSS devices are rated at 200,000 surge amps per phase, and will suppress lightning-induced transients, massive high energy surges, and power line spikes. Their surge suppression will greatly reduce equipment failures and computer lockups that are caused by power line disturbances. Operation is not affected by the power requirements of the load. Each line phase is fused, with a fuse status lamp. An unlikely failure will not interrupt power to the load. The Series 10 offers optional remote failure detection to monitor the suppression integrity of the device from a remote location. A Series 10 unit should be installed at the main entry electrical panel in any environment where frequent and severe lightning occurs.
What the judges had to say:
“This is the natural evolution of the product family.”
“Really keeps the power clean.”
626-355-3656
info@henryeng.com
www.henryeng.com
Do you have experience with this product? Share your comments below.
2010 Pick Hits
The 15 top new products of the 2010 NAB Show as selected by the Pick Hits panel of radio engineers….
2010 Pick Hits Rules
The Radio magazine Pick Hits are selected by following an established set of rules….
2010 Pick Hits Judges
The Radio magazine Pick Hits are selected by a panel of radio broadcast engineers. Unlike other convention awards, we tell you who the judges are….
