Sage Alerting Systems has released a firmware update for U.S. users only.
The company says that Version SI-rev5 must be installed to “permit your ENDEC to continue to receive EAS CAP alerts from FEMA. A FEMA signing certificate will expire at 11:55 p.m. EDT on Sept. 24, 2018; if you do not install this update, you will not receive CAP messages from the IPAWS system after that date.”
Sage notes that this update is similar but different than a May update (CR-rev4).
The installation of the new firmware will not change any settings on the ENDEC. Instructions can be found here.
Questions can be directed to [email protected] or call 1-914-872-4069.
